Euchner CES-I-AP-M-C04 (Multicode) Uživatelský manuál stáhnout pdf (Strana 18)

Operating Instructions Safety Switch CES-I-AP-M-C04

System status table

Operating mode

Actuator/door posi-

tion

Safety outputs FO1A

and FO1B

Monitoring output OD

LED indicator,

output

State

STATE (green)

DIA (red)

Normal operation

closed on on

Normal operation, door closed

closed on on

ﬂashing

quickly

Normal operation, door closed, actuator in limit range ¨ Re-adjust door

open off off

1 x Normal operation, door open

Fault display

closed off off

3 x Defective actuator (e.g. fault in code or code not readable)

X off off

4 x Output error (e.g. short circuits, loss of switching ability)

X off off

- Internal fault (e.g. component faulty, data error)

- Fault on the power supply (e.g. shutdown pulse duration for pulsed power supply too

long)

Key to symbols

LED not illuminated

LED illuminated

10 Hz (8 s)

LED ﬂashes for 8 seconds at 10 Hz

3 x

LED ﬂashes three times, and this is then repeated

X Any state

After the cause has been remedied, faults can generally be reset by opening

and closing the door. If the fault is still displayed afterward, brieﬂy interrupt the

power supply. Please contact the manufacturer if the fault could not be reset after

restarting.

Important!

If you do not ﬁnd the displayed device status in the System status table, this indi-

cates an internal device fault. In this case, you should contact the manufacturer.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Komentáře k této Příručce

Žádné komentáře

Euchner CES-I-AP-M-C04 (Multicode) Uživatelský manuál Strana 18

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnost Euchner CES-I-AP-M-C04 (Multicode)