Euchner CES-I-AR-M-C04 (Multicode) Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Bezpečnost Euchner CES-I-AR-M-C04 (Multicode). EUCHNER CES-I-AR-M-C04 (Multicode) User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk

Shrnutí obsahu

Strany 1 - CES-I-AR-M-C04 (Multicode)

More than safety.Operating InstructionsNon-Contact Safety SwitchCES-I-AR-M-C04 (Multicode)

Strany 2 - Contents

Operating Instructions Safety Switch CES-I-AR-M-C0410Caution! Ì In order to avoid EMC interference, the physical environmental and operating condition

Strany 3 - Correct use

Operating Instructions Safety Switch CES-I-AR-M-C0411Maximum cable lengthsSwitch chains are permitted up to a maximum overall cable length of 200 m ta

Strany 4

Operating Instructions Safety Switch CES-I-AR-M-C0412Determining cable lengths using the example tableExample: 6 switches are to be used in series. Ca

Strany 5 - General safety instructions

Operating Instructions Safety Switch CES-I-AR-M-C0413Connector assignment, safety switch CES-I-ARFigure 2: Connector assignment, safety switch CES-I-A

Strany 6 - Function

Operating Instructions Safety Switch CES-I-AR-M-C0414Connection of a single CES-I-ARIf a single CES-I-AR is used, connect the switch as shown in Figur

Strany 7

Operating Instructions Safety Switch CES-I-AR-M-C0415Warning!In case of an error, loss of the safety function through incorrect connection. Ì To ensur

Strany 8 - Mounting

Operating Instructions Safety Switch CES-I-AR-M-C0416Connection of several CES-I-AR in a switch chainImportant! Ì An AR switch chain may contain a max

Strany 9 - Electrical connection

Operating Instructions Safety Switch CES-I-AR-M-C0417Figure 5: Connection example for series connection with reset and changeover switch.Y-distributor

Strany 10 - Safety in case of faults

Operating Instructions Safety Switch CES-I-AR-M-C0418Notes on operation with safe control systemsPlease observe the following requirements for connect

Strany 11 - Maximum cable lengths

Operating Instructions Safety Switch CES-I-AR-M-C0419Safety OutputRead HeadSafety InputsRead HeadSafety OutputSafety InputsSafety InputsSafety OutputY

Strany 12 - = min. 75 mA

Operating Instructions Safety Switch CES-I-AR-M-C042ContentsAbout this document 3Correct use 3Possible combinations for CES components 4Exclusion o

Strany 13 - Coding lug

Operating Instructions Safety Switch CES-I-AR-M-C0420SetupLED indicatorsLED Color State SignificanceSTATEgreenillumi-natedNormal operation: Door closed

Strany 14 - Plug connector (8-pin)

Operating Instructions Safety Switch CES-I-AR-M-C0421System status tableOperating modeActuator/door posi-tionSafety outputs FO1A and FO1BMonitoring ou

Strany 15

Operating Instructions Safety Switch CES-I-AR-M-C0422Technical dataNote!If a product data sheet is included with the product, the information on the d

Strany 16

Operating Instructions Safety Switch CES-I-AR-M-C0423Typical system timesReady delay: After switching on, the unit carries out a self-test for 8 s. Th

Strany 17 - CES CESCES

Operating Instructions Safety Switch CES-I-AR-M-C0424Dimension drawings 10,6M12x1424,129,22583210,64,112,9ca. 1000 15,5 14,5 4,818Active faceLEDsActi

Strany 18

Operating Instructions Safety Switch CES-I-AR-M-C0425M12x1max. 45Ø 14,5Bridging plug 097645 4-pin, plugConnector assignment for safety switch CES-I-AR

Strany 19

Operating Instructions Safety Switch CES-I-AR-M-C0426Technical data for actuator CES-A-BBN-C04Parameter Value Unitmin. typ. max.Housing material Plast

Strany 20 - Functional check

Operating Instructions Safety Switch CES-I-AR-M-C0427Operating distancesOperating distance for center offset m = 0(only in combination with actuator C

Strany 21 - System status table

Operating Instructions Safety Switch CES-I-AR-M-C0428Technical data for actuator CES-A-BDN-06Parameter Value Unitmin. typ. max.Housing material Macrom

Strany 22 - Technical data

Operating Instructions Safety Switch CES-I-AR-M-C0429Ordering information and accessoriesDesignation Version Order no.CES-I-AR-M-C04-U05-119475 Safety

Strany 23 - Typical system times

Operating Instructions Safety Switch CES-I-AR-M-C043About this documentThis document is valid for all safety switches CES-I-AR-M-C04.Correct useThe Co

Strany 24

Operating Instructions Safety Switch CES-I-AR-M-C0430ServiceIf service support is required, please contact:EUCHNER GmbH + Co. KGKohlhammerstraße 16D-7

Strany 25 - Plug Socket

Operating Instructions Safety Switch CES-I-AR-M-C0431Declaration of conformity

Strany 26

Operating Instructions Safety Switch CES-I-AR-M-C0432

Strany 27

Operating Instructions Safety Switch CES-I-AR-M-C0433

Strany 28 - 1) With flush installation

More than safety.Euchner GmbH + Co. KGKohlhammerstraße 16D-70771 [email protected]:119562-04-05/14Title: Ope

Strany 29 - Inspection and service

Operating Instructions Safety Switch CES-I-AR-M-C044Important! Ì In the estimation of the PL for the overall system, a maximum value of 100 years can

Strany 30

Operating Instructions Safety Switch CES-I-AR-M-C045General safety instructionsSafety switches fulfill personal protection functions. Incorrect install

Strany 31 - Declaration of conformity

Operating Instructions Safety Switch CES-I-AR-M-C046FunctionThe device complies with the following safety requirements: Ì Safety category 4, PLe accor

Strany 32

Operating Instructions Safety Switch CES-I-AR-M-C047The system is designed so that failures will not result in the loss of the safety func-tion. The o

Strany 33

Operating Instructions Safety Switch CES-I-AR-M-C048MountingCaution!Risk of damage to equipment as a result of incorrect installation. Safety switches

Strany 34 - More than safety

Operating Instructions Safety Switch CES-I-AR-M-C049Electrical connectionThe following connection options are available: Ì Separate operation Ì Series

Komentáře k této Příručce

Žádné komentáře