Euchner AS-i 3.0 Command Interface Uživatelský manuál stáhnout pdf (Strana 49)

AS-i 3.0 Command Interface Commands of the Command Interface

Subject to reasonable modifications due to technical advances Id.-No.: 102875 Issue date - 3.12.2007 EUCHNER GmbH + Co. KG

Kohlhammerstraße 16, D-70771 Leinfelden-Echterdingen Tel. +49/711/7597-0, Fax +49/711/753316

4.5.10 Write parameter (WRITE_P)

The AS-i slave parameter value transferred with the command is passed on to the

addressed AS-i slave.

The parameter is stored in the AS-i Master only temporarily and is not stored as a

configured parameter in the EEPROM!

The AS-i slave transfers its current parameter value in the response (parameter

echo). This can deviate from the value that has just been written according to the

AS-i master specification.

Meaning of bit B:

B = 0 Single AS-i slave or A-slave

B = 1 B-slave

4.5.11 Read parameter (READ_PI: Read_Parameter)

This call returns the current parameter value (actual parameter) of an AS-i slave

sent by the AS-i Master. This value must not be confused with the parameter echo

that is supplied by the AS-i slave as a response to the write_p job.

This command can not be used for a directly reading of an AS-i parameter out of

an AS-i slave.

Request

byte

102

2T – circuit

3 – B slave address

4– parameter

Response

byte

102

2T result

3 – slave response

Request

byte

103

2T – circuit

3 – B slave address

Response

byte

103

2T result

3– PI

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 97 98

Žádné komentáře

Euchner AS-i 3.0 Command Interface Uživatelský manuál Strana 49